LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.3L Engine (Service Information) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Disconnect and isolate the negative battery cable.
  2. Remove the engine cover and air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION  .
  3. Remove the crankcase breather hose. Refer to TUBE, CRANKCASE BREATHER, REMOVAL AND INSTALLATION .
  4. Disconnect the oil vapor pipe quick coupling from the cylinder head cover.
  5. Remove the ignition coils. Refer to COIL, IGNITION, REMOVAL AND INSTALLATION .
    GC0189858Courtesy of CHRYSLER GROUP, LLC
  6. Unlock and disconnect the four Variable Valve Actuation Assembly (VVAA) wire harness connectors (1).
  7. Disengage the wire harness from the retainer (2).
    GC0190159Courtesy of CHRYSLER GROUP, LLC
  8. Remove the oil filler cap and dipstick (1).
  9. Unlock and disconnect the turbocharger air pressure sensor wire harness connector (2).
  10. Unlock and disconnect the turbocharger air temperature sensor wire harness connector (3).
  11. Unlock and disconnect the inlet air temperature (IAT) sensor wire harness connector (4).
  12. Unlock and disconnect the turbocharger wastegate actuator wire harness connector (5).
  13. Unlock and disconnect the turbocharger by-pass solenoid valve wire harness connector (6).
  14. Remove the bolts (7a), disengage the wiring harness retainers (7b) and reposition the wire harness (7c).
    GC0189947Courtesy of CHRYSLER GROUP, LLC
  15. Remove the bolt (1) securing the turbocharger air outlet pipe to the cylinder head cover.
    GC0189301Courtesy of CHRYSLER GROUP, LLC
  16. Release the quick coupling and disconnect the brake servo vacuum hose (1).
  17. Disengage the Oxygen sensor wire harness connector (2) from the wire harness support bracket.
  18. Disengage the wire harness from the retainer (3).
  19. Remove the bolts (4a) and reposition the wire harness support bracket (4b).
    GC0189707Courtesy of CHRYSLER GROUP, LLC
  20. Loosen the capture bolts (1a) and remove the cylinder head cover (1b).
  21. Remove any residual sealant from the cylinder head and cylinder head cover sealing surfaces.
scientia non olet · About LEMON Manuals