Removal And Installation: Installation
- Install NEW
gaskets (1a) and (1b) on the cylinder head cover.
- Apply sealant in the designated areas (1) on the cylinder head.
- Install the cylinder head cover onto the cylinder head.
- Using the sequence shown, tighten the cylinder head cover bolts to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install the wire harness support bracket and securely tighten the bolts.
- Engage the wire harness to the retainer.
- Engage the Oxygen sensor wire harness connector (2) to the wire harness support bracket.
- Connect the brake servo vacuum hose quick coupling.
- Install and securely tighten the bolt securing the turbocharger air outlet pipe to the cylinder head cover.
- Install the oil filler cap and dipstick.
- Position the wire harness, engage the wiring harness retainers and securely tighten the bolts.
- Connect and lock the four Variable Valve Actuation Assembly (VVAA) wire harness connectors.
- Connect and lock the turbocharger air pressure sensor wire harness connector.
- Connect and lock the inlet air temperature (IAT) sensor wire harness connector.
- Connect and lock the turbocharger air temperature sensor wire harness connector.
- Connect and lock the turbocharger wastegate actuator wire harness connector.
- Connect and lock the turbocharger by-pass solenoid valve wire harness connector.
- Install the ignition coils. Refer to COIL, IGNITION, REMOVAL AND INSTALLATION .
- Connect the oil vapor pipe quick coupling to the cylinder head cover.
- Install the crankcase breather hose. Refer to TUBE, CRANKCASE BREATHER, REMOVAL AND INSTALLATION .
- Install the air cleaner body and engine cover. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION .
- Connect the negative battery cable.