LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior/Exterior >> Seats >> Seat Cushion >> Removal

Seat Cushion: Removal

GC0084662Courtesy of CHRYSLER GROUP, LLC
NOTE:

The Occupant Detection Sensor (ODS) is part of the seat cushion foam.

  1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, WARNING .
  2. Remove the front seat. Refer to SEAT, FRONT, REMOVAL .
  3. Remove the bolts (2) and clamps (1) on the bottom side of the seat cushion.
  4. Disconnect the electrical connectors, if equipped.
    GC0145766Courtesy of CHRYSLER GROUP, LLC
  5. Separate the rear J-straps (1) and seat cushion cover and foam.
    GC0084663Courtesy of CHRYSLER GROUP, LLC
  6. Lift the front of the seat cushion (2) up and slide out from under the seat back cushion (1).
    GC0145767Courtesy of CHRYSLER GROUP, LLC
  7. Release the j-straps (1) and separate the seat cushion assembly from the seat pan.
    GC0145768Courtesy of CHRYSLER GROUP, LLC
  8. Unwrap the seat cushion cover from the seat cushion foam and release the hook and loop fasteners.
  9. While pulling down on the side of the seat cushion foam (3), slide out the retaining clips to separate the cover (1) from the foam.
scientia non olet · About LEMON Manuals