Audio/Video/Entertainment/Connectivity (Service Information): Radio: Removal

Disconnect the negative battery cable.
Remove the center trim bezel from the instrument panel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
CAUTION:
Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

Courtesy of CHRYSLER GROUP, LLC
Remove the four fasteners (1) securing the Radio Receiver Module (RRM) (2) to the instrument panel.
Pull the RRM out far enough to access the back of the RRM.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the antennas (2), and electrical connector (1).
If equipped, disconnect the USB connector (3).
Remove the RRM from the instrument panel.