Switch, Terrain Select: Installation

Courtesy of CHRYSLER GROUP, LLC

1. With the bezel tilted up in the back, position the terrain select switch (2) in the front of the bezel and seat the retaining clips (1).
2. Connect the wiring harness connector (3).

   Courtesy of CHRYSLER GROUP, LLC

3. Position the console bezel (1) and seat the retaining clips.

   Courtesy of CHRYSLER GROUP, LLC

4. Replace the yellow stamped clip (2) into the knob (1). The tab orients toward the outside of knob, not the centerline. The flat side of the clip (opposite the tab), should be on the inside, toward the shaft.

   Courtesy of CHRYSLER GROUP, LLC

5. Align the ribs on knob (1) with slots in the chrome shroud (2) and seat the shroud fully. Angle on the shroud must match the angle on the knob before snapping in place.

   Courtesy of CHRYSLER GROUP, LLC

6. Place the gear selector lever into the Park position.
7. Install the knob (1) onto the shift shaft and seat fully.