Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
CHECK FOR AN ACTIVE CONDITION
- With the scan tool, read DTCs and record on the repair order.
- Record the Freeze Frame Data and Environmental Data.
- With the scan tool, erase DTCs.
- Using the recorded Freeze Frame and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read DTCs.
Did the DTC return?
- This DTC is set to inform the technician that the vehicle has been in an accident and that the airbag module has deployed the airbags. No further diagnostics are required.
- Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .