LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (8HP45/845RE Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Installation >> Rear Wheel Drive

Rear Wheel Drive

WARNING: This page is about a different variant/trim than selected.
CAUTION:

The seal must be installed flush with the case. Driving the seal deeper could damage the seal causing a leak.

  1. Position the new output shaft seal over the output shaft and against the transmission case.
  2. Using (special tool #8481, Installer, Gear) install the output shaft seal.
  3. Verify that the transmission is in PARK in order to prepare for the installation of the output shaft nut.
  4. Install the propeller shaft flange onto the output shaft and install an NEW  flange nut. Tighten the nut, with a 34 mm 12 point socket, to 60 N.m (44 ft.lbs.).
  5. Stake the nut.
  6. Install the propeller shaft.
  7. Perform the CHECK OIL LEVEL procedure. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals