When Monitored
WARNING: This page is about a different variant/trim than selected.
- Continuously after the ignition switch is turned to the run position.
Set Condition:
- A failure is detected if one of the following conditions occurs:
- A short to battery failure is detected when the TCM detects a short to battery failure or the PWM feedback signal at the output stage is 0%.
- An open circuit or short to ground failure is detected when the TCM detects a short to ground or open circuit failure or the PWM feedback signal at the output stage is 100%.
- An open circuit failure is detected when the TCM detects an open circuit failure in reaction to the output stage being switch off after an open circuit or short to ground failure detection.
- A short to ground failure is detected when the TCM detects a short to ground failure in reaction to the output stage being switch off after an open circuit or short to ground failure detection.
Default Actions: