LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (8HP95 Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Removal >> Output Shaft Seal

Output Shaft Seal

WARNING: This page is about a different variant/trim than selected.
CAUTION:

Do not allow the propeller shaft to hang from the vehicle unsupported. Damage may occur to the joint, boot, and center bearing from over-angulation.

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0170214Courtesy of CHRYSLER GROUP, LLC
  2. Remove the drive shaft bolts (1) and washers (2) to transmission output flange and position aside the drive shaft. Secure the drive shaft with a strap or equivalent.
    GC0169779Courtesy of CHRYSLER GROUP, LLC
  3. Using a suitable punch, remove the staking (3) from the transmission output flange nut (2).
  4. Using (special tool #C-3281, Holder, Flange) (2) and a 34 mm 12 point socket, remove the transmission output flange nut (2).
  5. Remove the transmission output flange (1) and transmission output shaft dust seal.
  6. Remove the transmission output shaft seal with suitable screw and slide hammer.
scientia non olet · About LEMON Manuals