Transmission Oil Pump
WARNING: This page is about a different variant/trim than selected.
- Install the transmission oil pump seal (2).
- Install the transmission oil pump O-ring (2).
- Carefully seat the transmission oil pump into the housing, make sure the pump is seated properly.
- Install the two transmission oil pump housing halves together.
- Install six NEW transmission oil pump housing Torx® bolts (1).
- Tighten the bolts to 5 N.m (44 in. lbs) plus 45°.
- Replace the inner and outer transmission oil pump housing O-rings (1).
- Replace the A- piston seal (2) and install the A-piston (1).
- Install the belleville spring (1).
- Position the transmission oil pump housing assembly (4) in a suitable arbor press.
- Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the piston retaining ring to remove tension, and install the two halves of the split retainer ring (2).
- Install the hub (3).
- Install the clutches and spacers (4).
- Install the snap ring (2).
- Install the outer ring (1) (below B-piston).
- Position the B-piston alignment tab (2) above the notch and install B-piston (1) on the assembly.
- Install the transmission oil pump. Refer to PUMP, TRANSMISSION OIL, INSTALLATION .