Clutch, A: Assembly

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

1 - A CLUTCH PISTON

8 - SUN GEAR

2 - LIP SEAL

9 - WAVE SPRING

3 - LIP SEAL

10 - SEPARATOR PLATE

4 - RETURN SPRING

11 - FRICTION PLATES

5 - RING

12 - END PLATE

6 - BEARING

13 - SNAP RING

7 - WASHER

14 - SELECTABLE SHIM

NOTE:

If clutch discs are being replaced, soak in 8HP trans fluid before assembly.

Courtesy of CHRYSLER GROUP, LLC

Insert the piston and the retaining ring (1) into the housing.

Courtesy of CHRYSLER GROUP, LLC
Position the oil pump housing assembly (4) in a suitable arbor press.
Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the piston retaining ring to remove tension, and install the two halves of the split retainer ring (2).

Courtesy of CHRYSLER GROUP, LLC
Install the hub (3).
Install the clutches and spacers (4).
Install the snap ring (2).
Install the outer ring (1) (below B-piston).

Courtesy of CHRYSLER GROUP, LLC
Position the B-piston alignment tab (2) above the notch and install B-piston (1) on the assembly.
Install the transmission oil pump. Refer to PUMP, TRANSMISSION OIL, INSTALLATION .