LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (8HP70 Automatic Transmission (Service Information)) >> Standard Procedure >> E-Clutch Measurement

E-Clutch Measurement

WARNING: This page is about a different variant/trim than selected.
GC0154348Courtesy of CHRYSLER GROUP, LLC
  1. Place the E-clutch in a suitable arbor press.
  2. Using (special tool #10429, Gauge, Force) (1) and (special tool #8901A, Pressing Tool) (3) apply 200 N (45 lbs.) to the backing plate of the E-clutch.
  3. Using a set of feeler gauges (2), measure the gap between the backing plate and the retainer of the E-clutch.
  4. Refer to the clutch measurements table for specifications. If clearance is not within specifications, a thinner or thicker selectable backing plate can be installed to achieve proper clearance.
scientia non olet · About LEMON Manuals