LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (8HP70 Automatic Transmission (Service Information)) >> Standard Procedure >> C-Clutch Measurement

C-Clutch Measurement

WARNING: This page is about a different variant/trim than selected.
  1. Using (special tool #8901A, Pressing Tool) (2) and (special tool #10429, Gauge, Force) (1) place the C-clutch (3) in a suitable arbor press (with the backing plate facing up).
  2. Apply 200 N (45 lbs.) of force to the C-clutch to compress the wave plate.
  3. With a suitable feeler gauge, measure the gap between the C-clutch backing plate and the C-clutch retainer.
  4. Refer to clutch clearance table for specs. If clearance is not within specification a thinner or thicker selectable backing plate can be installed to achieve proper clearance.
GC0154623Courtesy of CHRYSLER GROUP, LLC
scientia non olet · About LEMON Manuals