LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (8HP70 Automatic Transmission (Service Information)) >> Pump, Transmission Oil >> Assembly

Pump, Transmission Oil: Assembly

WARNING: This page is about a different variant/trim than selected.
GC0154366Courtesy of CHRYSLER GROUP, LLC
  1. Install the oil pump seal (2).
    GC0154376Courtesy of CHRYSLER GROUP, LLC
  2. Install the oil pump O-ring (2).
  3. Carefully seat the oil pump into the housing, make sure the pump is seated properly.
    GC0154370Courtesy of CHRYSLER GROUP, LLC
  4. Install the two oil pump housing halves together.
    GC0154464Courtesy of CHRYSLER GROUP, LLC
  5. Install six NEW  oil pump housing Torx® bolts (1).
  6. Tighten the bolts to 5 N.m (44 in. lbs). plus 45°.
    GC0154629Courtesy of CHRYSLER GROUP, LLC
  7. Replace the inner and outer oil pump housing O-rings (1).
    GC0154658Courtesy of CHRYSLER GROUP, LLC
  8. Replace the A- piston seal (2) and install the A-piston (1).
    GC0152254Courtesy of CHRYSLER GROUP, LLC
  9. Install the belleville spring (1).
    GC0152251Courtesy of CHRYSLER GROUP, LLC
  10. Position the oil pump housing assembly (4) in a suitable arbor press.
  11. Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the piston retaining ring to remove tension, and install the two halves of the split retainer ring (2).
    GC0152250Courtesy of CHRYSLER GROUP, LLC
  12. Install the hub (3).
  13. Install the clutches and spacers (4).
  14. Install the snap ring (2).
  15. Install the outer ring (1) (below B-piston).
    GC0152288Courtesy of CHRYSLER GROUP, LLC
  16. Position the B-piston alignment tab (2) above the notch and install B-piston (1) on the assembly.
scientia non olet · About LEMON Manuals