Clutch C Assembly

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

1. Wave plate

2. Friction plate

3. Backing plate

4. Steel plate

NOTE:

If clutch discs are being replaced, soak in 8HP transmission fluid before assembly.

Courtesy of CHRYSLER GROUP, LLC

Replace the C-clutch seals (2).
Install C-clutch hub (1) onto the C-clutch shaft (3).

Courtesy of CHRYSLER GROUP, LLC
Install the backing plate (1).

Courtesy of CHRYSLER GROUP, LLC
Install 6 friction and steel clutch plates (1).

Courtesy of CHRYSLER GROUP, LLC
Install the wave plate (1).

Courtesy of CHRYSLER GROUP, LLC
Install the belleville spring (1).

Courtesy of CHRYSLER GROUP, LLC
Install the C-clutch piston (1).

Courtesy of CHRYSLER GROUP, LLC
Install the C-clutch retainer (1).

Courtesy of CHRYSLER GROUP, LLC
Place the C-clutch (2) in a suitable press.
Using special tool 8680 (1) compress the clutch enough to install the snap ring (3).
Install the snap ring (3).
Using (special tool #8901A, Pressing Tool) and (special tool #10429, Gauge, Force) measure the C-clutch clearance. Refer to clutch clearance chart for specifications.