When Monitored

This diagnostic runs continuously when the following conditions are met:

• Shifter is in the Drive or Reverse position.
• Transmission oil temperature is above a calibrated value.
• No clutch slip control functions commanded.
• No Input Speed Sensor signal Diagnostic Trouble Code (DTC)s set.
• Input Speed Sensor signal is above a calibrated value.
• Output Speed Sensor signal is valid or the output speed can be calculated from the wheel speed Controller Area Network (CAN) signal if the Output Speed Sensor signal is not available.
• Engine speed signal via CAN or output speed signal is above a calibrated value.
• During a gear shift:
  • The output speed and the output speed gradient must be higher than a calibrated value.
• When a gear is engaged:
  • The absolute value of the input speed gradient and pedal position must be lower than their respective calibrated values.