Set Condition
WARNING: This page is about a different variant/trim than selected.
- With gear engaged, one of the following conditions is present:
- Actual (calculated) gear differs from target (expected) gear.
- Turbine slip (difference between actual and calculated turbine speeds) is greater than 300 RPM.
- Calculated Transmission ratio is above calibrated value.
- During a down shift:
- Actual (calculated) gear is greater than target (expected) gear.
- Exception: Actual (calculated) gear is 1st and target (desired) gear is 2nd.
- Actual (calculated) gear is greater than target (expected) gear.