LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (6.2L Engine (Service Information)) >> Lubrication >> Pump, Engine Oil >> Installation

Pump, Engine Oil: Installation

WARNING: This page is about a different variant/trim than selected.
GC0088058Courtesy of CHRYSLER GROUP, LLC
  1. Gently push the oil pump (1) upwards and press firmly against the block. Finger tighten all of the retaining bolts (2) to ensure that the pump is fixed in it's position.
    Fig 1: Oil Pump Retaining Bolt Tightening Sequence
    GC0088115Courtesy of CHRYSLER GROUP, LLC
  2. Using the sequence shown in the illustration, tighten the oil pump retaining bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  3. Install the timing chain cover. Refer to COVER(S), ENGINE TIMING, INSTALLATION .
  4. Install the oil pump pickup tube and oil pan. Refer to PAN, OIL, INSTALLATION .
scientia non olet · About LEMON Manuals