LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (6.2L Engine (Service Information)) >> Air Intake System >> Air Cleaner >> Removal

Air Cleaner: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
    GC0180935Courtesy of CHRYSLER GROUP, LLC
  2. Remove the air cleaner housing cover retaining screws (4).
  3. Disconnect the Intake Air Temperature (IAT) sensor wire harness connector (3).
  4. Disconnect the make-up air hose (2).
  5. Loosen the clamp (1) and remove air cleaner housing cover and inlet tube assembly.
    GC0180955Courtesy of CHRYSLER GROUP, LLC
  6. Remove the air cleaner element (1) from the housing.
  7. Clean the inside of air cleaner housing before replacing element.
scientia non olet · About LEMON Manuals