LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (5.7L Engine (Service Information)) >> Engine Block >> Seal, Crankshaft Oil, Front >> Installation

Seal, Crankshaft Oil, Front: Installation

WARNING: This page is about a different variant/trim than selected.
GC0144946Courtesy of CHRYSLER GROUP, LLC
  1. Install the (special tool #10387, Installer, Vibration Damper) threaded rod (1) onto the crankshaft (2).
    GC0144950Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    The front crankshaft seal must be installed dry. Do not apply lubricant to the sealing lip or the outer edge.

  2. Using Crankshaft Front Oil Seal Installer (special tool #9072, Installer, Seal) (2) and (special tool #10387, Installer, Vibration Damper) (1), install the crankshaft front seal.
    GC0144947Courtesy of CHRYSLER GROUP, LLC
  3. Position the damper (2) onto the crankshaft.
  4. Using the (special tool #10387, Installer, Vibration Damper) (1), press the damper onto the crankshaft.
  5. Install the crankshaft damper bolt.
    GC0143968Courtesy of CHRYSLER GROUP, LLC
  6. Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration damper.
  7. Tighten the bolt to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  8. Install the cooling fan module. Refer to FAN, COOLING, INSTALLATION .
    GC0145666Courtesy of CHRYSLER GROUP, LLC
  9. Position the upper radiator hose and secure retainer (2) at the fan shroud.
  10. Install the upper radiator hose at the thermostat housing and secure hose clamp (1).
  11. Install the air cleaner resonator support bracket at the water pump.
  12. Install serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
    GC0144403Courtesy of CHRYSLER GROUP, LLC
  13. Connect the resonator hose to the throttle body and hand tighten the clamp (4).
  14. Install the resonator retaining bolt (3) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  15. Connect the clean air hose to the air cleaner housing and hand tighten the clamp (2).
  16. Connect the electrical connector at the Intake Air Temperature (IAT) sensor (1).
  17. Refill the cooling system. Refer to STANDARD PROCEDURE .
  18. Connect the battery negative cable. Tighten the nut to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
scientia non olet · About LEMON Manuals