LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (5.7L Engine (Service Information)) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Installation

Retainer, Crankshaft Rear Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Rear Seal Retainer Torque Sequence
GC0081773Courtesy of CHRYSLER GROUP, LLC
NOTE:

The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE:

The crankshaft rear oil seal retainer can not be reused after removal.

  1. Thoroughly clean all gasket residue from the engine block.
  2. Position the gasket onto the new crankshaft rear oil seal retainer.
  3. Position the crankshaft rear oil seal retainer onto the engine block.
  4. Using the sequence shown in the illustration, install the crankshaft rear oil seal retainer mounting bolts and tighten to 13 N.m (10 ft. lbs.).
  5. Install the oil pan. Refer to PAN, OIL, INSTALLATION .
  6. Install the flexplate. Refer to FLEXPLATE, INSTALLATION .
  7. Install the transmission. Refer to appropriate service information.
  8. Fill the engine with oil.
  9. Start the engine and check for leaks.
scientia non olet · About LEMON Manuals