Lifter(S), Hydraulic, Roller: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect and isolate the negative battery cable.
- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVAL .
- Remove the lifter guide holder retaining bolt (1) from the lifter guide holder assembly (2).CAUTION:
The lifter and retainer assembly must be installed as a unit.
CAUTION:If the lifter and retainer assembly are to be reused, identify the lifters to ensure installation in their original location or engine damage could result.
- Remove the lifter guide holder (1) and lifters (2) as an assembly.
- Check the camshaft lobes for abnormal wear.