LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (5.7L Engine (Service Information)) >> Engine Block >> Lifter(S), Hydraulic, Roller >> Installation

Lifter(S), Hydraulic, Roller: Installation

WARNING: This page is about a different variant/trim than selected.
GC0088081Courtesy of CHRYSLER GROUP, LLC

The Multiple Displacement System (MDS) provides cylinder deactivation during steady speed, low acceleration and shallow grade climbing conditions to increase fuel economy.

CAUTION:

Engines equipped with MDS use both standard roller lifters (2) and deactivating roller lifters (1). The deactivating roller lifters must be used in cylinders 1, 4, 6, 7. The deactivating lifters can be identified by the two holes in the side of the lifter body (3), for the latching pins.

CAUTION:

The lifter and retainer assembly must be installed as a unit.

GC0088082Courtesy of CHRYSLER GROUP, LLC
  1. Lubricate the lifter guide holder (1) and lifters (2).
    GC0088064Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    If the lifters and guide holder assembly are to be reused, they must me installed in their original location.

  2. Install the lifter guide holder (2) and lifters.
  3. Tighten the lifter guide holder retaining bolt (1) to 12 N.m. (9 ft. lbs.).
  4. Install the cylinder head. Refer to CYLINDER HEAD, INSTALLATION .
  5. Connect the negative battery cable.
    CAUTION:

    To prevent damage to valve assemblies, do not run the engine above fast idle until all hydraulic lifters have filled with oil and have become quiet.

  6. Start the engine and check for leaks.
  7. Road test the vehicle.
scientia non olet · About LEMON Manuals