Clutch E Disassembly

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

1. Wave plate

2. Friction plate

3. Backing plate

4. Steel plate

Courtesy of CHRYSLER GROUP, LLC

Place E-clutch (2) in a suitable press.
Using Pressing Tool 8901A
(special tool #8901A, Pressing Tool)

Courtesy of CHRYSLER GROUP, LLC

(1) compress the E-clutch piston enough to remove the snap ring (3).

Courtesy of CHRYSLER GROUP, LLC
Remove the E-clutch piston support (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the E-clutch piston (1).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Pay attention to the orientation of the plates.
Remove the wave washer (1), frictions and steels.

Courtesy of CHRYSLER GROUP, LLC
Remove the thrust plate (1) last.

Courtesy of CHRYSLER GROUP, LLC
Remove the belleville spring (2) from the E-clutch hub (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the E-clutch (1) seal (2) and O-ring (3).