LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Turbocharger System >> Cooler And Hoses, Charge Air >> Removal >> Hoses

Cooler And Hoses, Charge Air: Removal: Hoses

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the battery negative cable.
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
    GC0172154Courtesy of CHRYSLER GROUP, LLC
  3. Release the locking retainer (1) and remove the Charge Air Cooler (CAC) hose from the EGR Air flow control valve.
    GC0172132Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolts (2) securing the resonator (1).
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove the front suspension skid plate. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
    GC0172143Courtesy of CHRYSLER GROUP, LLC
  7. Loosen the clamp (1) and remove the right side CAC hose (2).
  8. Remove the support and lower the vehicle.
    GC0172128Courtesy of CHRYSLER GROUP, LLC
  9. Release the locking retainer (1) and remove the CAC hose (2) from the turbocharger.
    GC0172147Courtesy of CHRYSLER GROUP, LLC
  10. Remove the nut (1) and the CAC tube support (2) from upper timing cover.
    GC0172169Courtesy of CHRYSLER GROUP, LLC
  11. Loosen the clamp (2) and remove the left side CAC hose (1).
scientia non olet · About LEMON Manuals