LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Lubrication >> Sensor, Oil Temperature >> Installation

Sensor, Oil Temperature: Installation

WARNING: This page is about a different variant/trim than selected.
GC0145391Courtesy of CHRYSLER GROUP, LLC
  1. Install the oil temperature sensor (2) and tighten to 20 N.m (15 ft. lbs.).
    GC0158437Courtesy of CHRYSLER GROUP, LLC
  2. Connect the oil temperature sensor wire harness connector (2).
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  3. Install the engine cover (1).
  4. Connect the negative battery cable.
  5. Start engine and check for oil leaks.
scientia non olet · About LEMON Manuals