LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Lubrication >> Adapter, Oil Cooler >> Removal

Adapter, Oil Cooler: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
    GC0145586Courtesy of CHRYSLER GROUP, LLC
  3. Remove the cowl extension (1) and the side extensions (2, 5). Refer to SILENCER, COWL EXTENSION, REMOVAL .
  4. Remove the air cleaner body and air tube. Refer to BODY, AIR CLEANER, REMOVAL .
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove the front skid plate. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
  7. Drain the cooling system. Refer to STANDARD PROCEDURE .
  8. Drain the engine oil. Using a new sealing washer, install and tighten drain plug to 45 N.m (33 ft. lbs.).
  9. Remove the support and lower the vehicle.
    GC0158437Courtesy of CHRYSLER GROUP, LLC
  10. Disconnect the oil temperature sensor wire harness connector (2).
    GC0157454Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Oil temperature sensor removed for clarity.

  11. Disconnect the oil pressure sensor wire harness connector (2).
  12. Disconnect the coolant hose (1) from oil cooler adapter.
    NOTE:

    Removal of the A/C compressor does not require the refrigerant to be evacuated.

    GC0119532Courtesy of CHRYSLER GROUP, LLC
  13. Remove the A/C compressor and position aside. Refer to COMPRESSOR, A/C, REMOVAL .
    GC0146757Courtesy of CHRYSLER GROUP, LLC
  14. Remove the bolts (2), and the A/C compressor bracket (1).
    GC0146686Courtesy of CHRYSLER GROUP, LLC
  15. Remove the bolts (2) and the oil cooler adapter (1).
scientia non olet · About LEMON Manuals