Insulator, Engine Mount, Rear Mount: Removal

WARNING: This page is about a different variant/trim than selected.

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the skid plate, if equipped. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Gas engine shown in the illustration, Diesel engine similar.
Remove the four bolts (2) and the left crossmember brace (1).
Remove the two bolts (3) and the right crossmember brace (4).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Gas engine shown in the illustration, Diesel engine similar.
Remove the two bolts (2) from the rear engine mount isolator.
Using a suitable transmission jack and a block of wood positioned under the transmission oil pan, raise the transmission until the weight is off of the isolator (approximately 5 mm).
Remove the six bolts (3) and the crossmember (1).

Courtesy of CHRYSLER GROUP, LLC
On 4x4 models, remove the three bolts (2) and the rear transmission mount isolator (1).

Courtesy of CHRYSLER GROUP, LLC
On 4x2 models, remove the three bolts (2) and the rear transmission mount isolator (1).

Courtesy of CHRYSLER GROUP, LLC
On 4x2 models if required, remove four bolts (1) and the rear transmission mount bracket (2).