LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Left >> Removal

Insulator, Engine Mount, Left: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
  3. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
    GC0157461Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolts (1) and the left engine mount heat shield (2).
    GC0157459Courtesy of CHRYSLER GROUP, LLC
  5. Remove the bolts (2) and the right engine mount heat shield (1).
    GC0157456Courtesy of CHRYSLER GROUP, LLC
  6. Remove the left and right engine mount retaining nut (1).
  7. Using Engine Support Fixture (special tool #8534C, Fixture, Driveline Support), lift engine enough to gain access to the engine mount without damaging the turbocharger.
    GC0146735Courtesy of CHRYSLER GROUP, LLC
  8. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  9. Removed the belly pan.
  10. Remove the bolts (2) and the left engine mount (1).
    GC0146635Courtesy of CHRYSLER GROUP, LLC
  11. If necessary, remove the bolts (2) and the left engine mount bracket (1).
scientia non olet · About LEMON Manuals