LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Engine Block >> Rod, Piston And Connecting >> Removal >> Piston Pin

Piston Pin

WARNING: This page is about a different variant/trim than selected.
GC0146761Courtesy of CHRYSLER GROUP, LLC
  1. Secure the connecting rod (5) in a soft jawed vice.
  2. Remove the two snap rings (3) securing the piston pin (2).
  3. Push the piston pin (2) out of the piston (1) and the connecting rod (5).
  4. Remove the piston (1) from the connecting rod (5).
  5. Measure the diameter of the piston pin in the center and on both ends. Refer to ENGINE SPECIFICATIONS .
  6. Repeat this procedure for the remaining pistons and connecting rod assemblies.
scientia non olet · About LEMON Manuals