Piston Pin
WARNING: This page is about a different variant/trim than selected.
NOTE:
During piston assembly with the connecting rod pay attention concerning the arrow position on the piston crown (1) and the stamping on the connecting rod cap (2): the arrow and the stamping must oppose one another and cannot be on the same side.
- Secure the connecting rod (5) in a soft jawed vice.
- Lubricate the piston pin (2) and piston (1) with clean engine oil.
- Position the piston (1) onto connecting rod (5).
- Install the piston pin (2).
- Install the snap ring (3) into the piston (1) to retain piston pin (2).
- Remove the connecting rod (5) from the vice.