LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Engine Block >> Damper, Vibration >> Removal

Damper, Vibration: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate negative battery cable.
    GC0146755Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the Charge Air Cooler (CAC) hose (1) from the EGR air flow control valve and position aside.
    GC0146726Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the CAC hose from the resonator (3).
  4. Release the clips (1) and remove the charge air resonator (3) and position aside.
    GC0146792Courtesy of CHRYSLER GROUP, LLC
  5. Remove the bolts (1) and the vibration damper cover (2).
    GC0146633Courtesy of CHRYSLER GROUP, LLC
  6. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
  7. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  8. Remove the front skid plate. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
  9. Remove the front suspension skid plate. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
  10. Lock the engine 30 degrees ATDC. Refer to STANDARD PROCEDURE .
    GC0146664Courtesy of CHRYSLER GROUP, LLC
  11. Remove the support and lower the vehicle.
    NOTE:

    The crankshaft damper bolt is a left hand thread.

  12. Remove the bolt (1) and the vibration damper (2).
scientia non olet · About LEMON Manuals