LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Cylinder Head >> Valves, Intake And Exhaust >> Installation

Valves, Intake And Exhaust: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the valve back into the cylinder head in the same order as removed.
  2. Install NEW  valve guide seal.
  3. Install the spring and retainer.
  4. Use the Valve Spring Compressor Tool (special tool #C-3422-D, Compressor, Valve Spring) and Valve Spring Compressor Adapter (special tool #10224, Adapter, Valve Spring) and compress the valve spring and install the valve spring locks.
  5. Install the engine cylinder head. Refer to CYLINDER HEAD, INSTALLATION .
scientia non olet · About LEMON Manuals