LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Cylinder Head >> Spring(S), Valve >> Removal

Spring(S), Valve: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the cylinder head and place on work bench. Refer to CYLINDER HEAD, REMOVAL .
  3. Use Valve Spring Compressor Tool (special tool #C-3422-D, Compressor, Valve Spring) and Valve Spring Compressor Adapter (special tool #10224, Adapter, Valve Spring) and compress each valve spring.
  4. Remove the valve spring locks, retainer, and spring.
  5. Repeat this procedure for all cylinders.
scientia non olet · About LEMON Manuals