LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Cylinder Head >> Seal(S), Valve Guide >> Removal

Seal(S), Valve Guide: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the cylinder head and place on work bench. Refer to CYLINDER HEAD, REMOVAL .
    GC0095642Courtesy of CHRYSLER GROUP, LLC
  3. Use Valve Spring Compressor Tool (special tool #C-3422-D, Compressor, Valve Spring) and Valve Spring Compressor Adapter (special tool #10224, Adapter, Valve Spring) and compress each valve spring.
  4. Remove the valve locks, retainers, and springs.
  5. Remove the valve seal (1).
  6. Repeat this procedure for all cylinders.
scientia non olet · About LEMON Manuals