LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Cylinder Head >> Seal(S), Camshaft >> Installation

Seal(S), Camshaft: Installation

WARNING: This page is about a different variant/trim than selected.
GC0146771Courtesy of CHRYSLER GROUP, LLC
  1. Clean all the gasket sealing surfaces.
  2. Install the camshaft seals (2) into oil breather/camshaft seal housing (1).
    GC0146774Courtesy of CHRYSLER GROUP, LLC
  3. Using a NEW  gasket (3), install the oil breather/camshaft seal housing (2). Tighten the bolts (1) to 14 N.m (10 ft. lbs.).
    GC0169759Courtesy of CHRYSLER GROUP, LLC
  4. Install the crankcase pressure sensor. Refer to SENSOR, CRANKCASE PRESSURE, INSTALLATION .
  5. Connect the CCV hose (4) to oil breather/camshaft seal housing.
    GC0146726Courtesy of CHRYSLER GROUP, LLC
  6. Connect the CAC hose (2) to resonator (3).
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  7. Install the engine cover (1).
scientia non olet · About LEMON Manuals