Cylinder Head: Description
WARNING: This page is about a different variant/trim than selected.
The cylinder heads on the 3.0L V-6 are of a cross-flow design and have the following features:
- High-Strength Cast Aluminum Alloy Construction.
- Four Valves per Cylinder.
- Roller Finger Followers/Lifter Assemblies.
- Pressed-in Valve Guides and Valve Seats.
The 3.0L aluminum, overhead valve cylinder heads are made of high strength aluminum alloy and are each equipped with two camshafts, roller finger followers/lifter assemblies and four valve technology. The cylinder head can not be resurfaced. The cylinder head uses a Multi-layered Steel gasket for sealing. Anytime the cylinder head is removed a new gasket and bolts must be used.
The valve seats and valve guides are not serviceable.