LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal >> Right Bank

Right Bank

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the front skid plate. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
  4. Remove the front suspension skid plate. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
  5. Remove the lower engine oil dipstick bolt.
  6. Drain the cooling system. Refer to STANDARD PROCEDURE .
  7. Remove the support and lower the vehicle.
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  8. Remove the engine cover (1).
    GC0146726Courtesy of CHRYSLER GROUP, LLC
  9. Disconnect the Charge Air Cooler (CAC) hose at resonator (3).
  10. Remove the CAC hose (2) from the turbocharger.
  11. Release the clips and remove the charge air resonator (3).
    GC0145586Courtesy of CHRYSLER GROUP, LLC
  12. Remove the cowl extension (1) and the side extensions (2, 5). Refer to SILENCER, COWL EXTENSION, REMOVAL .
    GC0146725Courtesy of CHRYSLER GROUP, LLC
  13. Remove the coolant recovery bottle. Refer to BOTTLE, COOLANT RECOVERY, REMOVAL .
  14. Remove the generator. Refer to GENERATOR, REMOVAL .
    GC0145675Courtesy of CHRYSLER GROUP, LLC
  15. Remove the nuts and the HVAC air inlet housing (1).
  16. Remove the nut and the engine oil dip stick.
    GC0146791Courtesy of CHRYSLER GROUP, LLC
  17. Remove the bolts (1) and the right exhaust manifold heat shield (2).
    GC0158070Courtesy of CHRYSLER GROUP, LLC
  18. Disconnect the EGR valve wire harness connector (1).
    GC0146748Courtesy of CHRYSLER GROUP, LLC
  19. Disconnect the EGR cooler vacuum bypass hose (1).
    GC0158212Courtesy of CHRYSLER GROUP, LLC
  20. Remove the turbocharger-to-EGR cooler tube bolts (1).
  21. Remove the turbocharger-to-EGR cooler tube clamp (1).
    GC0146645Courtesy of CHRYSLER GROUP, LLC
  22. Remove the bolts (1 and 3) and the EGR cooler coolant tube (2).
    GC0146747Courtesy of CHRYSLER GROUP, LLC
  23. Disconnect the EGR cooler supply hose (1).
    GC0158004Courtesy of CHRYSLER GROUP, LLC
  24. Loosen the bolt (1) securing EGR cooler bypass valve support bracket (2).
  25. Remove the bolt (3) at the rear EGR cooler bypass valve support bracket (2).
    GC0146749Courtesy of CHRYSLER GROUP, LLC
  26. Remove the bolts (2) and the EGR and cooler assembly bracket (1).
  27. Remove the engine cover ball stud bracket at front of right cylinder head cover.
    GC0146598Courtesy of CHRYSLER GROUP, LLC
  28. Remove the right side fuel injectors. Refer to INJECTOR(S), FUEL, REMOVAL .
    GC0158000Courtesy of CHRYSLER GROUP, LLC
  29. Remove the nuts (2) and the turbocharger-to-EGR supply tube heat shield (1).
    GC0146717Courtesy of CHRYSLER GROUP, LLC
  30. Remove the bolts (1) and the cylinder head cover (2).
scientia non olet · About LEMON Manuals