Left Camshaft

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

Clean all gasket sealing and mating surfaces.
Lubricate the camshafts with Mopar® Engine Oil Supplement, or equivalent. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .
Carefully install the camshafts (1) onto cylinder head journals.

Courtesy of CHRYSLER GROUP, LLC
Set the intake camshaft gear timing mark (1) at the four O'clock position and the exhaust camshaft timing gear mark (2) to the seven O'clock position.

Courtesy of CHRYSLER GROUP, LLC
Verify the Identification No. (1) on front of cylinder head.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
When installing the bearing caps, be sure to install the "A" on the intake side and the "S" (1) on the exhaust side in the rightful order.
The identification No. (2) on the camshaft bearing cap should match the cylinder head number.

Courtesy of CHRYSLER GROUP, LLC
Install the camshaft bearing caps 1 through 12, 17 and 18 in the rightful order and tighten each retaining bolt finger tight.
Check the camshaft for proper timing. Refer to STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Using the tightening sequence shown in the illustration, tighten the bolts to 11 N.m (8 ft. lbs.).
Install the timing chain and sprocket. Refer to CHAIN AND SPROCKETS, TIMING, INSTALLATION .
Connect the negative battery cable.
Start engine, allow to warm, turn engine off and inspect for leaks.