LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (6.4L Engine (Service Information)) >> Engine Block >> Ring(S), Piston >> Standard Procedure >> Piston Ring Installation

Piston Ring Installation

WARNING: This page is about a different variant/trim than selected.
GC0080314Courtesy of CHRYSLER GROUP, LLC
  1. Install the oil ring expander.
  2. Install the lower side rail by placing one end between the piston ring groove and the expander ring (1). Hold the lower side rail end firmly and press down the portion to be installed until the side rail is in position. Repeat this step for the upper side rail.
    GC0095616Courtesy of CHRYSLER GROUP, LLC
  3. Using a piston ring installer, install the No. 2 intermediate piston ring.
  4. Using a piston ring installer, install the No. 1 upper piston ring.
    GC0095617Courtesy of CHRYSLER GROUP, LLC
  5. Install the oil ring expander gap at the (5) position.
  6. Install the oil ring lower side rail gap at the (4) position.
  7. Install the oil ring upper side rail gap at the (1) position.
  8. Install the second compression ring gap at the (5) position.
  9. Install the top compression ring gap at the (2) position.
scientia non olet · About LEMON Manuals