LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (6.4L Engine (Service Information)) >> Air Intake System >> Body, Air Cleaner >> Installation

Body, Air Cleaner: Installation

WARNING: This page is about a different variant/trim than selected.
GC0152258Courtesy of CHRYSLER GROUP, LLC
  1. If removed, install the air duct (3) to the air cleaner housing (1).
  2. While sliding the air duct onto the throttle body, lower the air cleaner housing into position and align the locating pins on the bottom of the housing.
  3. Install the makeup air hose (5) at the air cleaner housing.
  4. Connect the intake air temperature sensor electrical connector (4).
  5. Position the air duct retaining clamps (2) at the throttle body and air duct. Tighten to 3 N.m (30 in. lbs.).
scientia non olet · About LEMON Manuals