Converter, Catalytic: Removal: 5.7L/6.4L
| 1 - OXYGEN SENSOR |
| 2 - OXYGEN SENSOR CONNECTOR |
| 3 - BALL FLANGE NUT |
| 4 - LH CATALYTIC CONVERTER |
CAUTION:
When separating the catalytic converters from the manifolds, disconnect the oxygen sensor connectors. Allowing the catalytic converters to hang from the oxygen sensor wires damages the harness or sensors.
NOTE:
Left side shown, right side similar.
- Disconnect the negative battery cable.
- Raise and support the vehicle.
- Saturate all exhaust bolts and nuts with Mopar® Rust Penetrant. Allow five minutes for penetration.
- Disconnect the O2S sensor electrical connectors (2).
- Remove the catalytic converter to manifold flange nuts (3) and separate the catalytic converters (4) from the exhaust manifolds.
- Remove the front exhaust pipe band clamps (2) on the exhaust pipe/muffler and resonator assembly (1).
- Separate the exhaust pipe/muffler and resonator assembly from the catalytic converters (3 and 4).
- Remove the catalytic converters.