Lamp, Tail Stop Turn: Removal: Lamp: Outer
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Open the liftgate.
- Locate and remove the two bolts (1) that secures the bracket on the bottom of the inboard side of the outer rear tail lamp housing (2) to the upper flange of the rear fascia.
- Pull the outboard side of the lamp rearward far enough to disengage the two ball studs on the back of the lamp housing from the plastic grommets (3) in the lamp opening of the body sheet metal (4).
- Pull the lamp away from the vehicle far enough to access and disconnect the body wire harness connector (5) from the bulb socket connector receptacles on the back of the lamp housing.
- Remove the lamp from the vehicle.