LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (NV241 Or Transfer Case (Service Information)) >> Seal, Output Shaft, Rear Extension >> Removal

Seal, Output Shaft, Rear Extension: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support vehicle.
  2. Remove rear propeller shaft. Refer to SHAFT, DRIVE, REAR, REMOVAL .
  3. Remove the rear companion flange from the output shaft.
  4. Using a suitable pry tool or slide-hammer mounted screw, remove the rear extension seal.
scientia non olet · About LEMON Manuals