Motor, Sunroof: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not attempt to move or reposition the sunroof glass panel or drive cables with the sunroof motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.
WARNING:
The Sunroof Motor And Module Initialization procedure must be completed any time a sunroof motor and module unit is replaced with a new component. Failure to perform this procedure may result in damage to the vehicle, to the sunroof or in serious or fatal injuries.
NOTE:
For model year 2014 only, if vehicle is equipped with a power sunshade, BOTH sunroof motor and sunshade motor must be replaced together.
- Position the sunroof motor (4) close enough to the sunroof frame to access and connect the sunroof wire harness connector to the motor connector receptacle (3).
- Position the motor through the headliner bracket opening and onto the sunroof frame.
- Install and tighten the three screws (2) that secure the motor to the sunroof frame.NOTE:
For model year 2014 only, if vehicle is equipped with a power sunshade, BOTH sunroof motor and sunshade motor must be replaced together.
- Install the headliner (1) to the inner roof panel. Refer to HEADLINER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
- Perform the Sunroof Motor Initialization standard procedure. Refer to MOTOR, SUNROOF, STANDARD PROCEDURE .