Removal - PDC Assembly
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
For complete circuit diagrams, refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, further details on wire harness routing and retention, as well as pin-out and location views for the various wire harness connectors, splices and grounds.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the PDC cover.
- Disconnect the power feed connections from the PDC (3).
- Loosen the three screws (2) that secure upper tray of the PDC. These screws are captured and cannot be completely removed.
- Release the plastic clips that secure the PDC to the tray.
- The PDC upper tray will now lift upward. Carefully lift tray and disconnect the three bulkhead connectors (2) from the bottom.
- Remove the PDC tray from the vehicle.