Diagnostic Test

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
NOTE:
Vented seats must remain OFF during this test.
1. With the scan tool, read DTCs and record on the repair order.
2. Record the Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read CSWM DTCs.
  Is the same DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK THE (P922) RIGHT FRONT SEAT VENT RETURN CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the CSWM C5 harness connector.
3. Start the engine.
4. Measure the voltage between ground and the (P922) Right Front Seat Vent Return circuit at the CSWM C5 harness connector.
  Is the voltage 5.0 volts or above?
  
  Yes
  - Repair the (P922) Right Front Seat Vent Return circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK THE (P922) RIGHT FRONT SEAT VENT RETURN CIRCUIT FOR A SHORT TO ANOTHER CIRCUIT
1. Turn the ignition off.
2. Disconnect the Right Front Seat Cushion Vent Motor harness connector.
3. Disconnect the Right Front Seat Back Vent Motor harness connector.
4. Check for continuity between the (P922) Right Front Seat Vent Return circuit and all other circuits in the CSWM C5 harness connector.
  Is there continuity between the (P922) Right Front Seat Vent Return circuit and any other circuit?
  
  Yes
  - Repair the (P922) Right Front Seat Vent Return circuit for a short to another circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 4
CHECK THE VOLTAGE OF THE (P922) RIGHT FRONT SEAT VENT CONTROL CIRCUIT AT BOTH RIGHT FRONT SEAT VENT MOTOR HARNESS CONNECTORS
1. Reconnect the CSWM C5 harness connectors.
2. Start the engine.
3. Measure the voltage of the (P922) Right Front Seat Vent Control circuit at the Right Front Seat Cushion Vent Motor and the Right Front Seat Back Vent Motor harness connectors (harness side).
  Is the voltage 5.0 volts or above for either measurement?
  
  Yes
  - Replace the Comfort Seat Wheel Module (CSWM) in accordance with the Service Information. Refer to MODULE, COMFORT SEAT AND WHEEL (CSWM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Right Front Seat Vent Motors in accordance with the Service Information. Refer to MOTOR, VENTED SEAT, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .