Heated Steering Wheel
Vehicles equipped with the heated steering wheel option utilize a low voltage cut-off feature. This feature turns off power to the heated steering wheel anytime vehicle voltage is below 9.0 volts or above 16.0 volts. Be certain to check the vehicle electrical system for proper voltage anytime the heated steering wheel appears inoperative.
If a Diagnostic Trouble Code (DTC) can not be verified, it is a good indication that an INTERMITTENT fault condition may be present. To help find an intermittent problem, move the steering wheel around while testing continuity. Also wiggle the heated steering wheel wire harness and electrical connectors while testing continuity.
For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAMS article . Wiring Information includes wiring diagrams, connector pin-out and location views, details of wire harness routing and retention, splice and ground locations.
The Auto On feature is designed to function at an ambient temperature of 40° F or below. Make sure this option is enabled the customer programmable interface prior to diagnosis of an inoperative Auto On feature concern.
Before testing any individual components in the heated steering wheel system, check the following:
- Using a scan tool, check for any Diagnostic Trouble Codes (DTCs) related to the Comfort Seat and Wheel module (CSWM), U-Connect Touch ™ screen module and the Radio Receiver Module (RRM). If any DTCs are found, repair as necessary.
- Check the vehicles battery open-circuit voltage and charging system performance. If the vehicle's electrical system is defective or weak it may not be suppling sufficient energy to operate the heated steering wheel system.
- If there are no DTCs and the heated steering wheel system functions properly, but the heated steering wheel indicator does not illuminate, the entire U-Connect Touch ™ screen module must be replaced. Refer to RADIO, REMOVAL .