Diagnostic Test

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)

Turn the ignition on.
With the scan tool, read DTCs.
Does the scan tool display this DTC as active?

Yes
- Replace the Right Blind Spot Sensor in accordance with the Service Information. Refer to SENSOR, BLIND SPOT, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension. Repair as necessary. If no problems are found, test complete.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .