Diagnostic Test
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- VISUAL INSPECTION NOTE:
Make certain that the vehicle is not towing loads weighing more than the recommended towing capacity
- Check Transmission Cooler for airflow restrictions and internal fluid restrictions.
- Check Transmission fluid level and if low, check for leaks.
- Check Transmission Cooler lines for restrictions.
- Check Transmission case vent for restrictions.
Were any problems found?
Yes
- Repair in accordance with the Service Information.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
No
- Go To 2
- CHECK FOR OTHER TRANSMISSION DTCS
- With the scan tool, read TCM DTCs and record on the repair order.
Are there any other TCM DTCs?
Yes
- Repair the other TCM DTCs. Refer to TRANSMISSION CONTROL MODULE (TCM) - DIAGNOSTIC CODE INDEX .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
No
- Go To 3
- With the scan tool, read TCM DTCs and record on the repair order.
- CHECK TRANSMISSION TEMPERATURE SENSOR CIRCUITS FOR HIGH RESISTANCE
- Turn the ignition off.
- Disconnect the TCM harness connector.
- Disconnect the Transmission Assembly harness connector.
- Connect a jumper wire between the (T54) Transmission Temperature Signal circuit and the (T820) Sensor Ground circuit at the Transmission Assembly harness connector.
- Measure resistance between (T54) Transmission Temperature Signal circuit and the (T820) Sensor Ground circuit at the TCM harness connector.
Is the resistance below 3.0 Ohms?
Yes
- Replace the Transmission internal wiring harness in accordance with the Service Information. Refer to HARNESS, INTERNAL WIRE, REMOVAL .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
No
- Repair the (T54) Transmission Temperature Signal circuit or the (T820) Sensor Ground circuit for an open or high resistance.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .